Sammy-L21 V1.0 USB Modul
Product Categories
Rosahl Membranes for Keeping 3D-Print Filament Dry
Full Range of Rosahl Dehumidifer Membranes
Accessories, Power Supplies, Measurement
Kits for 3D-Print Filament kits-3d-print-filament-dryboxes
Microcontroller Modules
CodeVIsionAVR Compiler
Knowledge Base
Frequetly Asked Questions
Technical Documentation
Product Description
Sammy-L21 V1.0 is a versatile and very compact/small (just 18x38mm size!) microcontroller board with the SAML21G18B microcontroller and CP2102 USB UART converter. All relevant controller signals are available on pin headers. 16MHz XTAL and 32768Hz TOSC watch crystal are included.
The ultra-low-power ATSAML21 based Flash microcontroller (MCU) feature sophisticated power management technologies and consumes under 35μA/MHz in active mode and 200nA in Sleep mode. In addition to ultra-low-power performance, these devices feature Full Speed USB host and device, Event System and Sleepwalking, 12-bit analog, AES, capacitive touch sensing, built in opAmps and much more.
The microcontroller module is shipped without preassembled pin headers, since everybody has different preferences or requirements. A Connector Kit with a suitable set of pin headers and receptacles can be ordered optionally.
New: The Sammy-L21 can be ordered with preloaded chip45bootSAM Bootloader. With the free chip45bootSAM Windows GUI the application (hex file) can be uploaded through USB. No additional programming tool is necessary.
You can find further information in the Infosheet.
Technical Details of the SAM L21 Board
- ARM Cortex-M0+ based MCU running up to 48MHz
- 256KB embedded Flash and 32KB SRAM
- Low power consumption at <70μA/MHz
- DMA and Event system
- Six flexible serial communication modules (SERCOM)
- Full-Speed USB Device and embedded Host
- 12-bit ADC (14 channels) ; 10-bit DAC
- Hardware touch support
- 16MHz XTAL and 32768Hz TOSC watch crystal
- 3.3V LDO voltage regulator
- optionaler Pufferkondensator für Power Off SRAM Backup
- 16MHz XTAL crystal and 32768Hz TOSC watch crystal
- Connectors: 2x 32-pin with all processor signals and CAN bus, 1x 8-pin with USB and RS232 Signalen, 1x 6-pin ISP, mini USB-B (5-pin)
- 2.54mm (1/10inch) pin spacing
- Size: 17.78mm x 38.1mm
Downloads
- Sammy-L21 V1.0 Infosheet
- Sammy-L21 V1.0 Schematic Diagram
- Atmel/Microchip SAML21G18B Homepage
- Atmel/Microchip SAML21G18B Datasheet
- chip45bootSAM Bootloader Windows GUI
- Atmel Studio 7 integrated development platform (IDP) for developing and debugging all AVR and SAM microcontroller applications
- Atmel Start online tool for intuitive, graphical configuration of embedded software projects